Hardware requirements

  • Micro USB cable

  • evkcmimxrt1060 board

  • Personal Computer

  • One of the following WiFi modules:

  • One of the following modules:

    • Embedded Artists 1XK M.2 Module (EAR00385) - direct M2 connection.

    • Embedded Artists 1ZM M.2 Module (EAR00364) - direct M2 connection.

    • Embedded Artists 2EL M.2 Module - direct M2 connection.

    • Embedded Artists 2DS M.2 Module (EAR00386) - direct M2 connection.

Board settings

Jumper settings for RT1060-EVKC (enables external 5V supply):

  • remove J40 5-6

  • connect J40 1-2

  • connect J45 with external power(controlled by SW6)

Murata Solution Board settings

  • Embedded Artists 1XK module datasheet: https://www.embeddedartists.com/doc/ds/1XK_M2_Datasheet.pdf

  • Embedded Artists 1ZM module datasheet: https://www.embeddedartists.com/doc/ds/1ZM_M2_Datasheet.pdf

  • Embedded Artists 2EL module datasheet: https://www.embeddedartists.com/doc/ds/2EL_M2_Datasheet.pdf

  • Embedded Artists 2DS module datasheet: https://www.embeddedartists.com/doc/ds/2DS_M2_Datasheet.pdf

RT1060-EVKC Board Rework For M2 Slot Enablement

  • Wi-Fi Rework:

    • Jumper Settings : Connect J109, connect J76 2-3

    • For 2DS M.2 Module: remove R2163

  • Wi-Fi Host Sleep Wakeup GPIO For 1XK/1ZM/2EL:

    • add 0Ohm resistor at position R252

    • 1XK:

      • Connect Fly-Wire between J33.1 and J108.5.

      • J108 is routed on M2.P44 which internally routed on GPIO[2] of Controller 1XK.

    • 1ZM:

      • Connect Fly-Wire between J33.1 and J108.2.

      • J108 is routed on M2.P40 which internally routed on GPIO[13] of Controller 1ZM.

    • 2EL:

      • No fly-wire connection required.

  • Wi-Fi Independent Reset OOB Trigger For 1XK/1ZM/2EL:

    • Connect Fly-Wire between J16.1 and J108.4.

    • J108 is routed on M2.P48 which internally routed on IR GPIO[15] of Controller 1XK/1ZM.

    • For 2EL-M2, No fly-wire connection required.